Temperature_Checking.vhd

library IEEE;
use IEEE.STD_LOGIC_1164.ALL;

-- Uncomment the following library declaration if using
-- arithmetic functions with Signed or Unsigned values
--use IEEE.NUMERIC_STD.ALL;

-- Uncomment the following library declaration if instantiating
-- any Xilinx leaf cells in this code.
--library UNISIM;
--use UNISIM.VComponents.all;

entity Digital_Block is
    port (
        DIN0, DIN1, DIN2, DIN3, DIN4, DIN5, DIN6, DIN7: in std_logic; -- 8 bit ADC In, DIN0 (MSB), DIN7 (LSB)
        CLK : in std_logic; -- External Clock In
        RST : in std_logic; -- Reset Signal
        DOUT1 : out std_logic; -- Serial Out
        AOUT1 : out std_logic; -- Yellow LED Control
        AOUT2 : out std_logic; -- Red LED Control
        AOUT3 : out std_logic -- Green LED Control
    );
end Digital_Block;

architecture Behavioral of Digital_Block is -- Declare architecture

    signal Temp : std_logic_vector(7 downto 0); --Define a 8 bits signal containing temperature
    constant Min_Temp : std_logic_vector(7 downto 0) := "00011100"; -- Define a temperature of -25 Degree Celsius
    constant Max_Temp : std_logic_vector(7 downto 0) := "11100011"; -- Define a temperature of +75 Degree Celsius
    constant Zero_Temp : std_logic_vector(7 downto 0) := "01001110"; -- Define a temperature of 0 Degree Celsius
    constant Device_ID : std_logic_vector(3 downto 0) := "0001"; -- Define the Device ID
    signal Byte : std_logic_vector(11 downto 0); -- Merge Device ID & Temperature
    signal Right_Shift : std_logic_vector(11 downto 0); -- Right shift register
    signal Counter : integer range 0 to 20 := 0; -- Define "20 seconds" (Assuming 1MHz clock frequency)
    signal Serial_Out : integer range 0 to 11; -- Count for shift register

begin
    process (CLK) -- Set CLK as sensitive signal
    begin
        Temp <= DIN0 & DIN1 & DIN2 & DIN3 & DIN4 & DIN5 & DIN6 & DIN7; -- Write ADC signal into temperature
        Byte <= Device_ID & Temp; -- Merge Device ID and Temperature
        AOUT1 <= '0';
        AOUT2 <= '0';
        AOUT3 <= '0';
        
        if Temp < Min_Temp or Temp > Max_Temp then
        AOUT1 <= '1'; -- illuminate Yellow LED
        AOUT2 <= '0';
        AOUT3 <= '0';
        elsif Temp < Zero_Temp and Temp > Min_Temp then
        AOUT1 <= '0'; 
        AOUT2 <= '1'; -- illuminate Red LED
        AOUT3 <= '0';
        elsif Temp > Zero_Temp and Temp < Max_Temp then
        AOUT1 <= '0'; 
        AOUT2 <= '0';
        AOUT3 <= '1'; -- illuminate Green LED
        end if;
    end process;
    DOUT1 <= Right_Shift(0); -- Output LSB
end Behavioral;