When using the flux fill feature the output appears as a completely blurred image.

[xvpowerg]

Steps I've Taken
Reviewed Issue #1457 for reference.
Followed the installation instructions to ensure all necessary models are installed.
Did not configure the extra_model_paths.yaml file.
Confirmed that my models are properly installed and work with other functionalities in ComfyUI.
Environment Details:
Operating System: win11
ComfyUI Version:v0.3.6

[moranshuanghua]

i have same issue ，outpaint，inpaint is wrong

[Njasa2k]

what is the cfg?

[xvpowerg]

cfg:1

[agoulddesign]

cfg:1

If it recognizes it as a Flux Fill model it should override this setting and default to flux guidance of 30. Dump the workflow (Interface setting) and load into a Comfy window to see if this is happening.

You probably need to disable the old inpaint model.

[xvpowerg]

Solution Found
After further investigation and thanks to the community's suggestions, I discovered the issue:
The Flux Fill feature cannot be used simultaneously with the FLUX.1-dev-Controlnet-Inpainting-Beta.safetensors model. If you want to use Flux Fill as the fill method, you must remove the FLUX.1-dev-Controlnet-Inpainting-Beta.safetensors file from the controlnet folder.

Steps to Resolve
Navigate to the controlnet folder in your ComfyUI installation.
Remove or move the FLUX.1-dev-Controlnet-Inpainting-Beta.safetensors file.
Restart ComfyUI.
Test the Flux Fill feature again—it should now work as expected.
Acknowledgment
Thank you to everyone who provided guidance and suggestions. Your support was invaluable in helping me identify and resolve this issue.