v1.1.0

[Architeuthis-Flux]

This release allows the new DACs to work on Revision 3, and Revision 2 boards should work too.

To use the DACs from Wokwi, connect the signal pin from a potentiometer somewhere in the circuit (I'll make a custom Wokwi chip soon so this looks nicer but for now this works):

• pot1:SIG will connect to DAC 0 (0-5V)
• pot2:SIG will connect to DAC 1 (+-8V)

note: pots are numbered by the order you place them, so if you just want DAC 1, first place another potentiometer somewhere to be DAC 0 and just don't connect it to anything

ADCs are connected with the D0-3 on the logic analyzer part in Wokwi:

• logic1:D0 will connect to ADC 0 (0-5V) - GPIO 26
• logic1:D1 will connect to ADC 1 (0-5V) - GPIO 27
• logic1:D2 will connect to ADC 2 (0-5V) - GPIO 28
• logic1:D3 will connect to ADC 3 (+-8V) - GPIO 29

I'll write a guide for all this soon

Also you can also adjust the LED brightnesses for different net types from the TUI.

The app remains unchanged.

---

This discussion was created from the release v1.1.0.