BVM Fails after running the windows update #147
Replies: 3 comments 8 replies
-
|
There was a similar issue in the past which seemed to be solved with some tweaks I made that remove a problematic driver. |
Beta Was this translation helpful? Give feedback.
-
|
Thank you for the response! I will have to check that tomorrow morning:) I have it all shut down at the moment... I actually reinstalled windows turned off updates, and it worked again but I haven't done any update again yet. Do you select the "direct" view mode in the drop down where Romania is? |
Beta Was this translation helpful? Give feedback.
-
|
Yes. If you encounter this issue again, please don't reinstall windows. Please instead ask for help before doing anything, so I can actually help you. It benefits everybody this way :) |
Beta Was this translation helpful? Give feedback.
-
|
Sorry I haven't had a chance to mess with this system at all the last few days... been rather busy! I do have a question for you... when I went and pulled the ISO it actually pulled 25H2... I was hoping to stay on 24H2... is there any way to do that with this? |
Beta Was this translation helpful? Give feedback.
-
|
Okay... I had some time today... I ran the full updates in windows 11 Pro 25H2 and when I get a reboot it hung... so I went direct, waited for a while and then it seemed to work through the process and everything updated properly and it is working fine:) Thanks for the advice!!! |
Beta Was this translation helpful? Give feedback.
-
|
I do have a question for you... When I exit Windows, it comes back to the terminal and then it just hangs at the "Considered supporting the developer Boxspot." but sometimes it doesn't tell me to close the terminal? |
Beta Was this translation helpful? Give feedback.
-
|
Ok, thanks! Hopefully I will have some time today to mess with it:) |
Beta Was this translation helpful? Give feedback.
-
I'm not aware of a way to automate requesting a specific ESD release from microsoft.
Interesting. Could you describe "the process"? Was it a blue colored screen that said windows was updating? Or did it say windows needed to complete some repairs? |
Beta Was this translation helpful? Give feedback.
-
|
Pretty simple process... once it went to the reboot and it came back and said it couldn't connect so I closed it and then I attempted to reopen windows and it goes to listen and it just hangs... so I closed that again and I selected direct and just let it run through the process and I think part of the problem was it was such a large update on the Pi-5 it just took way too long... but it didn't give me any error messages:) |
Beta Was this translation helpful? Give feedback.
-
|
With the direct method I could actually see that it was doing things in the background:) |
Beta Was this translation helpful? Give feedback.
-
|
Once it was all updated in all cleaned up, I then went back and ran it through Remmina, which I like the setup! |
Beta Was this translation helpful? Give feedback.
Uh oh!
There was an error while loading. Please reload this page.
-
After running the install process everything was running great. Then windows did an update and when it did the reboot BVM listens on 3389 for two min. and fails. Any idea what is going on and what I can do about it? I actually restarted it several times before the windows update and it worked fine...
Beta Was this translation helpful? Give feedback.
All reactions