Missing 220V Bed Settings in Configuration.h

[Snoopy354]

#if ENABLED(PIDTEMPBED)

//#define PID_BED_DEBUG // Sends debug data to the serial port.

//120V 250W silicone heater into 4mm borosilicate (MendelMax 1.5+)
//from FOPDT model - kp=.39 Tp=405 Tdead=66, Tc set to 79.2, aggressive factor of .15 (vs .1, 1, 10)
#define DEFAULT_bedKp 138.56
#define DEFAULT_bedKi 24.51
#define DEFAULT_bedKd 195.80

//120V 250W silicone heater into 4mm borosilicate (MendelMax 1.5+)
//from pidautotune
//#define DEFAULT_bedKp 97.1
//#define DEFAULT_bedKi 1.41
//#define DEFAULT_bedKd 1675.16

// FIND YOUR OWN: "M303 E-1 C8 S90" to run autotune on the bed at 90 degreesC for 8 cycles.
#endif // PIDTEMPBED

What is for 220V Bed?

Thanks

[smirnov-tk]

@Snoopy354 you know, but even same model printer have individual PID settings.
You can find your own using this gcode command: M303 E-1 C8 S90, then apply it using M340 command and save using M500 command.
You can google for tutorial.