diff --git a/imap_processing/hit/packet_definitions/P_HIT_HSKP.xml b/imap_processing/hit/packet_definitions/P_HIT_HSKP.xml new file mode 100644 index 000000000..303f471c4 --- /dev/null +++ b/imap_processing/hit/packet_definitions/P_HIT_HSKP.xml @@ -0,0 +1,344 @@ + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + 640 + + + + + + + CCSDS Packet Version Number (always 0) + + + CCSDS Packet Type Indicator (0=telemetry) + + + CCSDS Packet Secondary Header Flag (always 1) + + + CCSDS Packet Application Process ID + + + CCSDS Packet Grouping Flags (3=not part of group) + + + CCSDS Packet Sequence Count (increments with each new packet) + + + CCSDS Packet Length (number of bytes after Packet length minus 1) + + + Spacecraft tick + Spacecraft tick + + + Mode (0=boot, 1=maint, 2=stdby, 3=science + + + FSW version number (A.B.C bits) + + + FSW version number (A.B.C bits) + + + FSW version number (A.B.C bits) + + + Number of good commands + + + Last good command + + + Last good sequence number + + + Number of bad commands + + + Last bad command + + + Last bad sequence number + + + FEE running (1) or reset (0) + + + MRAM disabled (1) or enabled (0) + + + spare + + + 50kHz enabled (1) or disabled (0) + + + HVPS enabled (1) or disabled (0) + + + Table status OK (1) or error (0) + + + Heater control (0=none, 1=pri, 2=sec) + + + ADC mode (0=quiet, 1=normal, 2=adcstim, 3=adcThreshold?) + + + Dynamic threshold level (0-3) + + + spare + + + Number of events since last HK update + + + Number of errors + + + Last error number + + + Code checksum + + + Spin period at t=0 + + + Spin period at t=0 + + + + PHASIC status + + + Active heater + + + Heater on/off + + + Test pulser on/off + + + DAC_0 enable + + + DAC_1 enable + + + Reserved + + + Preamp L234A + + + Preamp L1A + + + Preamp L1B + + + Preamp L234B + + + FEE LDO Regulator + Mounted on the board next to the low-dropout regulator + + + Primary Heater + Mounted on the board next to the primary heater circuit + + + FEE FPGA + Mounted on the board next to the FPGA + + + Secondary Heater + Mounted on the board next to the secondary heater + + + + Chassis temp + Mounted on analog board, close to thermostats, heaters, and chassis + + + Board temp + Mounted inside the faraday cage in the middle of the board near the connector side. + + + LDO Temp + Mounted on top of the low-dropout regulator + + + Board temp + Mounted in the middle of the board on the opposite side of the hottest component + + + 3.4VD Ebox (digital) + + + 5.1VD Ebox (digital) + + + +12VA Ebox (analog) + + + -12VA Ebox (analog) + + + +5.7VA Ebox (analog) + + + -5.7VA Ebox (analog) + + + +5Vref + + + L1A/B Bias + + + L2A/B Bias + + + L3/4A Bias + + + L3/4B Bias + + + +2.0VD Ebox (digital) + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + \ No newline at end of file