A lower deck panel addition to the V0, designed to accomodate a Neopixel Ring.
-
Deck_Logo_Insert_Transparent
- Printed with a clear filament to allow for the glow that is represented in the pictures.
- Recommend >40% infill to hide the individual LEDs.
-
Deck_Logo
- This is meant to be printed with no top or bottom layers, leaving the infill pattern exposed for light to shine through.
- Perimeters (vertical): 2 or 3
- Solid Layers (horizontal): 0 Top and 0 Bottom
- Infill Pattern: I recommend a pattern like "Honeycomb", "Stars" or similar. The main goal is to be able to see through the print.
- Infill Density: This will vary depending on your infill pattern and personal preference. Play around with it to get the look that you want.
The parts are pressed and snapped together then attached to the lower deck panel via VHB tape.
I used two Neopixel Rings (a 24 and a 12) in my build, but only one is required. VHB tape was also used to secure these to the deck panel. I then drilled a hole through the deck to accomodate the wires necessary to run to an Arduino Nano as a controller.
The lights can be controlled with an Arduino Nano, Klipper, or an Octoprint Plugin.
