-
Hi. I've run several succesful G7 sessions with xdrip but now I could not get the new sensor to pair. Things that I've done;
No luck. |
Beta Was this translation helpful? Give feedback.
Replies: 10 comments 21 replies
-
I have experienced this same issue. And I can recreate it as well. A guaranteed solution is to uninstall xDrip (a bad thing) and reinstall. This is something I hope we will improve. But, I cannot guarantee we can. |
Beta Was this translation helpful? Give feedback.
-
So ok, its something in the keks library I believe, |
Beta Was this translation helpful? Give feedback.
-
Move your old G7 out of range should fix it or it is supposed to resolve by itself if you just wait. |
Beta Was this translation helpful? Give feedback.
-
@kakoni which xDrip version are you using? |
Beta Was this translation helpful? Give feedback.
-
@kakoni that xdrip version should be fine. Double check that your transmitter number is a number, if there is 0 then it is a 0 not an O and ensure that any previously used sensors are a long way away as they can be the source of mismatch errors. |
Beta Was this translation helpful? Give feedback.
-
Beta Was this translation helpful? Give feedback.
-
Sorry, I went to bed and, at some point, it started reading. I'm sure there was not a stop option, but I'm not sure if there was a start option. |
Beta Was this translation helpful? Give feedback.
-
I thought that maybe xDrip was not able to detect the new sensor because the old G7 session was still running. |
Beta Was this translation helpful? Give feedback.
-
So just started new session (3 days, early, old one died in sensor error). Based on discussion here's what I did
No problems. |
Beta Was this translation helpful? Give feedback.
-
There is a Smoothing option under Display Settings Menu in xDrip+, but I'm not sure how it works. |
Beta Was this translation helpful? Give feedback.
I have experienced this same issue. And I can recreate it as well.
I have test phones that I use to monitor the voltages of my used G7 devices because I am creating a log of how fast the battery voltages drop. It happens all the time when I keep switching the transmitter ID.
I tell you what I do and I will also tell the the side effect. Please read everything.
A guaranteed solution is to uninstall xDrip (a bad thing) and reinstall.
Obviously, after you reinstall, you will need to scan the QR code again.
I say uninstalling xDrip is bad because if you uninstall xDrip, you will lose the database and all your settings.
You can create a backup of both.
But, my database is not very important to…