How to use Simplicity Commander? #53
-
|
@silabs-bozont I saw that in few issues you suggest that the users can erase the flash of the EFR32 using the Simplicity Commander which comes with the Silabs Arduino core. On MacOS the commander doesn't seem to be able to find the Nano Matter board connected to it. I have Jlink Utilities installed and JlinkConfing can find the device. I also tried to run commander from cli and to set the adapter using adapter probe --serialno but it doesn't work again. Can you share with me how can I use the commander utility with Arduino Nano Matter? |
Beta Was this translation helpful? Give feedback.
Replies: 1 comment 1 reply
-
|
Hello @miroslavpetrov, |
Beta Was this translation helpful? Give feedback.
-
|
thank you for the clarification. |
Beta Was this translation helpful? Give feedback.
Hello @miroslavpetrov,
As opposed to the Silicon Labs branded kits the Arduino Nano Matter does not use J-Link - therefore it's not compatible with Simplicity Commander or any of the J-Link utilities.
The Nano Matter uses OpenOCD - which is a bit different. The Arduino IDE now offers erasing support as well with the 2.0.0 version - so you can also erase your board just by using the Arduino IDE.
To do that - select
Tools > Burn Bootloaderafter selectingOpenOCDas your programmer in the Arduino IDE. This will do a full erase on your board, then burn the bootloader.