Even on the newest version that says it should stop the 29 minute error im still getting it

[nkyzr929hc-netizen]

These are my settings

[albert-mueller]

I just tested it as well at the same time you are reporting the issue:

[albert-mueller]

@Medelcartelinc

[Medelcartelinc]

Hey @nkyzr929hc-netizen, the "29 minutes remaining" error is a classic macOS installer issue. It happens exactly when the installer tries to verify and flash a firmware update (EFI/bridgeOS), fails because of the unsupported hardware, and gets stuck.
Usually, this is bypassed by tricking the installer into thinking it's running inside a Virtual Machine, which forces it to skip all firmware checks. Could you double-check your OpenCore build settings? Make sure you have RestrictEvents enabled and that VMM spoofing (revpatch=sbvmm or similar boot-args) is properly injected in your config.plist. If you are manually spoofing the SMBIOS, ensure the board-id matches a supported model for the macOS version you are trying to install.

[nkyzr929hc-netizen]

To what model should i spoof bcs everything you say is correct here. Im currently spoofed to macpro7,1 but one thing board id is empty everywhere when i check in OCAT