Command line tool to create self signed SSL certificate
Based on the following amazing GIST.
NOTE!
-
This only works on MAC!
-
Requires Node version 8 or higher
In the folder of your project use the NPM executer:
npx create-ssl-certificate
This will create a certificate for the domain: FOLDER_NAME.test and any subdomain.
npx create-ssl-certificate --hostname myproject
This will create a certificate for the domain: myproject.test and any subdomain.
npx create-ssl-certificate --hostname myproject --domain localhost
This will create a certificate for the domain: myproject.test and any subdomain. Only test
and localhost
are recommended because they are specifically reserved as special-use domains.
You choose either 1. or 2.
This setup only works for the specific hostname and no subdomains. Add the following, where you replace hostname and top level domin name to your own configuration:
127.0.0.1 myproject.test
to your /etc/hosts
file.
You can do a "one time" setup, which works on all hostnames for the given top level domain, etc. .test
. A good solution is dnsmasq. Install it via homebrew.
brew install dnsmasq
To make it start when your mac boots up:
brew services start dnsmasq
To route all top level domain lookups to localhost you will have to run these commands.
Replace test
in both echo commands if you chose a different top level domain.
mkdir -pv $(brew --prefix)/etc
sudo cp -v $(brew --prefix dnsmasq)/homebrew.mxcl.dnsmasq.plist /Library/LaunchDaemons
sudo launchctl load -w /Library/LaunchDaemons/homebrew.mxcl.dnsmasq.plist
sudo mkdir -pv /etc/resolver
echo "address=/.test/127.0.0.1" | sudo tee -a $(brew --prefix)/etc/dnsmasq.conf
echo "nameserver 127.0.0.1" | sudo tee /etc/resolver/test
You usually have to restart your computer for this to take proper effect.