You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
I bought two leadscrew package. One for the lathe and one to drive a agriculture seeder.
My problem is that the tractor I have (Fendt 516) sends 100 pulses every driven meter. I only have one signalcable and ground and don't know how to connect it to the board since the rotary controller have more conektion cables?
I understand that the "multiple" in the program may have to change to give the correkt speed on the steppermotor but I can't get it to run smothly with the pulse from the traktor.
Does anyone know how I should connect the signal cable to the bord instead of the rotarycontroller?
Nabe
The text was updated successfully, but these errors were encountered:
I bought two leadscrew package. One for the lathe and one to drive a agriculture seeder.
My problem is that the tractor I have (Fendt 516) sends 100 pulses every driven meter. I only have one signalcable and ground and don't know how to connect it to the board since the rotary controller have more conektion cables?
I understand that the "multiple" in the program may have to change to give the correkt speed on the steppermotor but I can't get it to run smothly with the pulse from the traktor.
Does anyone know how I should connect the signal cable to the bord instead of the rotarycontroller?
Nabe
The text was updated successfully, but these errors were encountered: