How do I default the system to Parallel 1P OD? #741
-
Hi! I'm flashing The documentation says
which implies that the system is only required to be set when using the universal firmware but that shouldn't effect the parallel_1p specific firmware right? Am I doing something wrong?/Is there a way to default to Parallel_1P_OD without going into the setting on a computer? Thanks for taking the time to read! |
Beta Was this translation helpful? Give feedback.
Replies: 4 comments 5 replies
-
This line if for "universal" firmware. if you use specific firmware, dont touch the system option, leave it auto. |
Beta Was this translation helpful? Give feedback.
-
When flashing the specific firmware |
Beta Was this translation helpful? Give feedback.
-
before.txt is the logs after a factory reset. The controller doesn't work after.txt is the logs after changing from AUTO to Parallel_1P_OD at https://blueretro.io/advance.html and the controller does work |
Beta Was this translation helpful? Give feedback.
-
It was a typo in the config for that specific build That one should work: |
Beta Was this translation helpful? Give feedback.
It was a typo in the config for that specific build
That one should work:
v1.8.3-138-g8831e52_hw1.zip