3DO Fz-10 (Anvil) adapter hasn't input

[CarloScalabrin]

Hello everyone, I'm facing some problems to get Blureretro Core to work on the 3DO FZ-10 with Anvil chip. I am using pmgducati's PCB design. On Fz-1 and Fz-10 with DSP Clio it works normally, however on Fz-10 models with DSP Anvil, it does not work. The core has power, the control pairs normally, but there is no button input. Any tips/suggestions?

[darthcloud]

I'm not sure what my FZ-10 revision is. I'll have to check.

@DoomyDoomer did you by any chance test with both version of the FZ-10?

[CarloScalabrin]

I did a test on fz-10 with "clio" and works perfectly.

[DoomyDoomer]

My FZ-10 appears to be a Japanese CLIO, 1994 model.

[CarloScalabrin]

Ok Guys, so do you think that it is necessary to open an issue? @darthcloud and @DoomyDoomer

[DoomyDoomer]

Might be good to open a ticket just so it's tracked. I'm not sure what adapter (or DIY solution) you're using but FWIW, my adapter has been on the market for awhile now and I haven't heard of this issue before. It even works with the M2 prototypes.

[darthcloud]

I opened a bug to track this, but it will only get resolve if I can get my hand on the HW to troubleshoot.