printer.cfg

#[include kiauh_macros.cfg]
[include ./conf/main_printer.cfg]
[include ./conf/user_vars.cfg]
[include ./conf/steppers.cfg]
[include ./conf/extruder.cfg]
[include ./conf/heaters.cfg]
[include ./conf/probe.cfg]
[include ./conf/stealthburner_leds.cfg]
[include ./conf/z_calibration.cfg]
[include ./conf/resonance.cfg]
[include ./conf/sensor.cfg]
[include ./conf/fans.cfg]
# [include ./conf/leds.cfg]
#[include ./conf/klicky.cfg]
# [include ./conf/displays.cfg]
[include ./conf/klicky/klicky-probe.cfg]
[include ./conf/slicer.cfg]
#[include ./config/klicky/klicky-bed-mesh-calibrate.cfg]
#[include ./config/klicky/klicky-quad-gantry-level.cfg]
#[include ./config/klicky/klicky-specific.cfg]
[include ./conf/temperature.cfg]
[include ./conf/nozzle_scrub.cfg]

[include ./conf/adaptive_bed_mesh.cfg]

[include ./conf/macros.cfg]
# [include ./conf/portable_input_shaper.cfg]

#*# <---------------------- SAVE_CONFIG ---------------------->
#*# DO NOT EDIT THIS BLOCK OR BELOW. The contents are auto-generated.
#*#
#*# [heater_bed]
#*# control = pid
#*# pid_kp = 43.920
#*# pid_ki = 1.388
#*# pid_kd = 347.519
#*#
#*# [extruder]
#*# control = pid
#*# pid_kp = 23.205
#*# pid_ki = 1.074
#*# pid_kd = 125.306
#*#
#*# [stepper_z]
#*# position_endstop = 2.400