The mode in the device information section sometimes does not display or cannot be adjusted

[BI6NSL]

What happened? How can it be reproduced? Provide as much information as possible.

Just as the title suggests, the mode in the device information section sometimes does not display/cannot be adjusted

When the software was first launched, everything was normal. However, after I turned off the drilling rig and started it again, the mode on the right side of the equipment would not be displayed and could not be switched

QLog Version

0.45.0

Which OS are you using?

Windows

QLog Installation Method

EXE

Installation Details

No response

[aa5sh]

Can you share a picture of your rig definition screen in settings?

[BI6NSL]

[aa5sh]

When you say you are turning off the polling are you going to Equipment Menu and unchecking Radio? Or what steps are you doing. Since it looks like you are connecting to a rigctld instance just want to understand your steps. It is apparent that something is not being restarted cleanly when you restart polling.

[BI6NSL]

After closing the RIG, disconnecting the power supply, and then re-opening the RIG, the mode adjustment was lost

[BI6NSL]

The drop-down menu cannot pop up to switch modes

After closing the RIG, disconnecting the power supply, and then re-opening the RIG, the mode adjustment was lost

The drop-down menu cannot pop up to switch modes

[aa5sh]

Ok one thing to make sure, since your using rigctld are you killing that instance when powering down and starting it back up after you power back on? Then restarting the rig through the menu?

…

On Aug 26, 2025, at 1:33 PM, Junxi Wang ***@***.***> wrote: BI6NSL left a comment (foldynl/QLog#738) <#738 (comment)> The drop-down menu cannot pop up to switch modes After closing the RIG, disconnecting the power supply, and then re-opening the RIG, the mode adjustment was lost The drop-down menu cannot pop up to switch modes — Reply to this email directly, view it on GitHub <#738 (comment)>, or unsubscribe <https://github.com/notifications/unsubscribe-auth/AUEEMXVCLO25CKXSEYT6VRL3PSR55AVCNFSM6AAAAACEZTUGD2VHI2DSMVQWIX3LMV43OSLTON2WKQ3PNVWWK3TUHMZTEMRVGI4DAMZTHE>. You are receiving this because you commented.

[BI6NSL]

Ok one thing to make sure, since your using rigctld are you killing that instance when powering down and starting it back up after you power back on? Then restarting the rig through the menu?
…

I only manually turned off the drilling rig but not the rigctld program. When I manually turned on the drilling rig power again, I needed to restart the Qlog to switch between various modes on the Qlog once more

[BI6NSL]

After the above operation, I tried to close Qlog and then open it again. The mode switch popped up normally and returned to normal.