-
Notifications
You must be signed in to change notification settings - Fork 0
/
Life.srf
51 lines (51 loc) · 7.52 KB
/
Life.srf
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
{ "" "" "" "Variable or input pin \"data_b\" is defined but never used." { } { } 0 287013 "" 0 0 "Design Software" 0 -1 0 ""}
{ "" "" "" "Found combinational loop of 47 nodes" { } { } 0 332125 "" 0 0 "Design Software" 0 -1 0 ""}
{ "" "" "" "LOCKED port on the PLL is not properly connected on instance \"pll_hdmi:pll_hdmi\|pll_hdmi_0002:pll_hdmi_inst\|altera_pll:altera_pll_i\|general\[0\].gpll\". The LOCKED port on the PLL should be connected when the FBOUTCLK port is connected. Although it is unnecessary to connect the LOCKED signal, any logic driven off of an output clock of the PLL will not know when the PLL is locked and ready." { } { } 0 21300 "" 0 0 "Design Software" 0 -1 0 ""}
{ "" "" "" "Net \"soc_system:soc_system\|soc_system_Video_Output:video_output\|alt_vip_cvo_core:cvo_core\|genlock_enable_sync1\[1\]\" is missing source, defaulting to GND" { } { } 0 12110 "" 0 0 "Design Software" 0 -1 0 ""}
{ "" "" "" "Inferred RAM node \"zxspectrum:emu\|mist_io:mist_io\|ps2_kbd_fifo_rtl_0\" from synchronous design logic. Pass-through logic has been added to match the read-during-write behavior of the original design." { } { } 0 276020 "" 0 0 "Design Software" 0 -1 0 ""}
{ "" "" "" "Inferred RAM node \"zxspectrum:emu\|mist_io:mist_io\|ps2_mouse_fifo_rtl_0\" from synchronous design logic. Pass-through logic has been added to match the read-during-write behavior of the original design." { } { } 0 276020 "" 0 0 "Design Software" 0 -1 0 ""}
{ "" "" "" "No destination clock period was found satisfying the set_net_delay assignment from \"\[get_keepers \{soc_system\|video_output\|cvo_core\|mode_banks\|h_sync_polarity_reg\}\]\" to \"\[get_keepers \{soc_system\|video_output\|cvo_core\|mode_banks\|vid_h_sync_polarity\}\]\". This assignment will be ignored." { } { } 0 17897 "" 0 0 "Design Software" 0 -1 0 ""}
{ "" "" "" "No destination clock period was found satisfying the set_net_delay assignment from \"\[get_keepers \{soc_system\|video_output\|cvo_core\|mode_banks\|v_sync_polarity_reg\}\]\" to \"\[get_keepers \{soc_system\|video_output\|cvo_core\|mode_banks\|vid_v_sync_polarity\}\]\". This assignment will be ignored." { } { } 0 17897 "" 0 0 "Design Software" 0 -1 0 ""}
{ "" "" "" "No destination clock period was found satisfying the set_net_delay assignment from \"\[get_keepers \{soc_system\|video_output\|cvo_core\|mode_banks\|interlaced_field_reg\[*\]\}\]\" to \"\[get_keepers \{soc_system\|video_output\|cvo_core\|mode_banks\|vid_interlaced_field\[*\]\}\]\". This assignment will be ignored." { } { } 0 17897 "" 0 0 "Design Software" 0 -1 0 ""}
{ "" "" "" "Some pins have incomplete I/O assignments. Refer to the I/O Assignment Warnings report for details" { } { } 0 15714 "" 0 0 "Design Software" 0 -1 0 ""}
{ "" "" "" "55 hierarchies have connectivity warnings - see the Connectivity Checks report folder" { } { } 0 12241 "" 0 0 "Design Software" 0 -1 0 ""}
{ "" "" "" "Inferred RAM node \"emu:emu\|mister_io:mister_io\|ps2_kbd_fifo_rtl_0\" from synchronous design logic. Pass-through logic has been added to match the read-during-write behavior of the original design." { } { } 0 276020 "" 0 0 "Design Software" 0 -1 0 ""}
{ "" "" "" "Inferred RAM node \"emu:emu\|mister_io:mister_io\|ps2_mouse_fifo_rtl_0\" from synchronous design logic. Pass-through logic has been added to match the read-during-write behavior of the original design." { } { } 0 276020 "" 0 0 "Design Software" 0 -1 0 ""}
{ "" "" "" "Verilog HDL or VHDL warning at de10_top.v(97): object \"io_win\" assigned a value but never read" { } { } 0 10036 "" 0 0 "Design Software" 0 -1 0 ""}
{ "" "" "" "Verilog HDL or VHDL warning at de10_top.v(102): object \"io_sdd\" assigned a value but never read" { } { } 0 10036 "" 0 0 "Design Software" 0 -1 0 ""}
{ "" "" "" "Overwriting existing clock: vip\|hps\|fpga_interfaces\|clocks_resets\|h2f_user0_clk" { } { } 0 332043 "" 0 0 "Design Software" 0 -1 0 ""}
{ "" "" "" "Variable or input pin \"data_a\" is defined but never used." { } { } 0 287013 "" 0 0 "Design Software" 0 -1 0 ""}
{ "" "" "" "*" { } { } 0 169085 "" 0 0 "Design Software" 0 -1 0 ""}
{ "" "" "" "*" { } { } 0 174073 "" 0 0 "Design Software" 0 -1 0 ""}
{ "" "" "" "*" { } { } 0 332174 "" 0 0 "Design Software" 0 -1 0 ""}
{ "" "" "" "*" { } { } 0 13009 "" 0 0 "Design Software" 0 -1 0 ""}
{ "" "" "" "*" { } { } 0 21300 "" 0 0 "Design Software" 0 -1 0 ""}
{ "" "" "" "alt_vip_cvo_mode_banks" { } { } 0 9999 "" 0 0 "Design Software" 0 -1 0 ""}
{ "" "" "" "hps_sdram_pll.sv" { } { } 0 9999 "" 0 0 "Design Software" 0 -1 0 ""}
{ "" "" "" "alt_vip_common_frame_counter.v" { } { } 0 9999 "" 0 0 "Design Software" 0 -1 0 ""}
{ "" "" "" "hps_sdram_p0_acv_hard_memphy.v" { } { } 0 9999 "" 0 0 "Design Software" 0 -1 0 ""}
{ "" "" "" "hps_sdram_p0_acv_ldc.v" { } { } 0 9999 "" 0 0 "Design Software" 0 -1 0 ""}
{ "" "" "" "hps_sdram_p0_acv_hard_io_pads.v" { } { } 0 9999 "" 0 0 "Design Software" 0 -1 0 ""}
{ "" "" "" "altera_mem_if_hard_memory_controller_top_cyclonev.sv" { } { } 0 9999 "" 0 0 "Design Software" 0 -1 0 ""}
{ "" "" "" "genlock_enable_sync" { } { } 0 9999 "" 0 0 "Design Software" 0 -1 0 ""}
{ "" "" "" "u_calculate_mode" { } { } 0 9999 "" 0 0 "Design Software" 0 -1 0 ""}
{ "" "" "" "genlock_enable" { } { } 0 9999 "" 0 0 "Design Software" 0 -1 0 ""}
{ "" "" "" "reset_value" { } { } 0 9999 "" 0 0 "Design Software" 0 -1 0 ""}
{ "" "" "" "soc_system:soc_system\|soc_system_pll_video:pll_video\|altera_pll:altera_pll_i\|general\[0\].gpll" { } { } 0 9999 "" 0 0 "Design Software" 0 -1 0 ""}
{ "" "" "" "alt_vip_cvo_core.sdc" { } { } 0 9999 "" 0 0 "Design Software" 0 -1 0 ""}
{ "" "" "" "alt_vip_packet_transfer.sdc" { } { } 0 9999 "" 0 0 "Design Software" 0 -1 0 ""}
{ "" "" "" "hps_sdram_p0.sdc" { } { } 0 9999 "" 0 0 "Design Software" 0 -1 0 ""}
{ "" "" "" "alt_vip_common_dc_mixed_widths_fifo.sdc" { } { } 0 9999 "" 0 0 "Design Software" 0 -1 0 ""}
{ "" "" "" "altera_mem_if_hhp_qseq_synth_top" { } { } 0 9999 "" 0 0 "Design Software" 0 -1 0 ""}
{ "" "" "" "soc_system:soc_system\|soc_system_vip_vout:vip_vout\|alt_vip_cvo_core:cvo_core\|genlock_enable_sync1" { } { } 0 9999 "" 0 0 "Design Software" 0 -1 0 ""}
{ "" "" "" "soc_system:soc_system\|soc_system_vip_fb:vip_fb\|alt_vip_packet_transfer:pkt_trans_rd\|alt_vip_packet_transfer_read_proc:READ_BLOCK.read_proc_instance\|alt_vip_common_fifo2:output_msg_queue\|scfifo:scfifo_component\|scfifo_scd1:auto_generated\|a_dpfifo_e471:dpfifo\|altsyncram_ums1:FIFOram\|q_b" { } { } 0 9999 "" 0 0 "Design Software" 0 -1 0 ""}
{ "" "" "" "soc_system:soc_system\|soc_system_Video_Input:video_input\|alt_vip_cvi_core:cvi_core\|alt_vip_cvi_write_fifo_buffer:write_fifo_buffer" { } { } 0 9999 "" 0 0 "Design Software" 0 -1 0 ""}
{ "" "" "" "soc_system:soc_system\|soc_system_Frame_Buffer:frame_buffer\|alt_vip_packet_transfer:pkt_trans_rd" { } { } 0 9999 "" 0 0 "Design Software" 0 -1 0 ""}
{ "" "" "" "soc_system_hps_fpga_interfaces.sdc" { } { } 0 9999 "" 0 0 "Design Software" 0 -1 0 ""}
{ "" "" "" "soc_system_HPS_fpga_interfaces.sdc" { } { } 0 9999 "" 0 0 "Design Software" 0 -1 0 ""}
{ "" "" "" "RST" { } { } 0 9999 "" 0 0 "Design Software" 0 -1 0 ""}
{ "" "" "" "alt_vip_scaler_alg_core" { } { } 0 9999 "" 0 0 "Design Software" 0 -1 0 ""}
{ "" "" "" "cvo_core" { } { } 0 9999 "" 0 0 "Design Software" 0 -1 0 ""}
{ "" "" "" "vip_HPS_fpga_interfaces.sdc" { } { } 0 9999 "" 0 0 "Design Software" 0 -1 0 ""}
{ "" "" "" "alt_vip_dil_vof_scheduler.sdc" { } { } 0 9999 "" 0 0 "Design Software" 0 -1 0 ""}
{ "" "" "" "alt_vip_dil_scheduler.sdc" { } { } 0 9999 "" 0 0 "Design Software" 0 -1 0 ""}