INAV configurator restart when click Alignment tool on demo mode

[jonathanoeijoeng]

I found that INAV configurator 8.0.1 on demo mode always restart when I click Alignment tool. Other tabs are OK

Regards,
Jonathan

INAV.mov

[thespova]

This is happening to me even not in demo mode. Also on 8.0.1

[b14ckyy]

Because you are in CLI Mode. To end CLI mode, the FC has to reboot. This reboot causes a disconnect and is expected. Nothing wrong there.

So every time you enter CLI you MUST reboot and reconnect the FC before you can any other tab again.

[jonathanoeijoeng]

Please see this new video that I didn't even click CLI

Screen.Recording.2025-06-07.at.18.00.09.mov

[b14ckyy]

Well, that's why it is important to provide issue reports with proper information. There is a reason why there is a content template when opening a new ticket, that you completely ignored and deleted.

[b14ckyy]

For me the specific tabs works. It can happen that occasionally I get a disconnect. There is a stability issue present in configurator that we still try to pin down with no luck so far. But in your case I think its just a faulty configuration.

make a CLI backup of your config if necessary. Then type in defaults to reset the config to firmware defaults. Then try again.

20250607-1116-43.2012766.mp4

[thespova]

Well, that's why it is important to provide issue reports with proper information. There is a reason why there is a content template when opening a new ticket, that you completely ignored and deleted.

Maybe there was some confusion here. I am a different reporter than the one who opened the ticket. In the original post is all the information I needed to try and see if I was having the same issue. Including the video.

Where is this content template?

[thespova]

Side note, for me the same issue happens if I try to use demo mode on 8.0.0. Iv never used Demo mode before so very possible I dont have something set right but I thought id try to replicate the OP issue on 8.0.0.

It gives me
":12:50 -- MSP connection successfully closed

2025-06-07 @ 21:12:50 -- Error: read ECONNRESET"

However on 8.0.0 but with the FC on 8.0.1 I can connect to a quad and then go to the alignment tool with no issue.

[thespova]

And now upgrading back to 8.0.1 I can again access the alignment tool tab when connected to my drown.

If I try it in demo mode I get the same as the op, closing the connection. The error is the same as on 8.0.0 for me.

"2025-06-07 @ 21:20:19 -- Error: read ECONNRESET"

[thespova]

For me connection reset 100% of the time within 1 second of clicking on the alignment tab in demo mode for 8.0.1 & 8.0.0