Skip to content

Latest commit

 

History

History
78 lines (40 loc) · 3.17 KB

DRAWINGS.md

File metadata and controls

78 lines (40 loc) · 3.17 KB

P2-BLDC-Motor-Control - DRAWINGs

Single and Two-motor driver objects P2 Spin2/Pasm2 for our 6.5" Hub Motors with Universal Motor Driver Board

Project Maintenance

License

Drawing Files

These are the two design files I sent off to be make by SendCutSend.com - their prices are quite good!:

1. Platform Board

Drawing File - outboard wheels (.dwg) - I spec'd 0.250" MDF as the material at ~$29 USD. File w/Outboard Wheels

NOTE: the 8 center small holes (for M3 screws) are for mounting the twin motor boards connected to the Mini Edge Breakout Board (#64019) or the newer Edge Breakout Board (#64029). The inner-most 4 holes are for the new, smaller RevB boards, while the outer four are for the larger RevA motor boards.

There are 2 ea. holes for each motor (for 1/4" - 20 Screws.)

There are 4 ea. holes for each castor - (for 1/4" - 20 Screws.). One of the castor holes is longer to provide access to the hex nut.

2. Spacer Board

Drawing File - spacer to drop motors below castors (.dwg) - I spec'd 0.025" MDF as the material w/Ten of these for ~$14.20 USD.
Spacer

There are 2 ea. holes for each spacer board (shim) (for 1/4" - 20 Screws.)

Packaging (order arrives)

This is what I found when I opened my order:

Opened Package The Package arrived with these contents.. This was quite well packaged. The MDF part was shrink-wrapped to the backing cardboard. The laser cuts were all clean with a little bit of scorch mark on one side of the MDF as you might expect.


If you like my work and/or this has helped you in some way then feel free to help me out for a couple of ☕'s or 🍕 slices!

coffee    -OR-    PatreonPatreon.com/IronSheep


Older Drawing Files

These are my earlier designs including the version you see in the pictures above.

  1. OLD: Drawing File - outboard wheels (.dwg) - I spec'd 0.250" MDF as the material at ~$29 USD. File w/Outboard Wheels
  2. OLD: Drawing File - enclosed wheels (.dwg) - I spec'd 0.250" MDF as the material at ~$29 USD. File w/Enclosed Wheels

Disclaimer and Legal

Parallax, Propeller Spin, and the Parallax and Propeller Hat logos are trademarks of Parallax Inc., dba Parallax Semiconductor


License

Licensed under the MIT License.

Follow these links for more information: