update hardware info

Author: jantman

docs/source/hardware.rst

@@ -39,7 +39,7 @@ This is intended to work with `esphome-configs/2024.6.4/no-current-input.yaml </
 
 * RFID Reader - Note that if using the same model that I did, you must add a solder blob on ``S2`` for Wiegand output.
 
-  * ``CST`` to ``GPIO25``
+  * ``CST`` to ``GPIO18``
   * ``Gnd`` to ground
   * ``TX/D0`` to ``GPIO16``
   * ``RX/D1`` to ``GPIO4``

hardware/v1_mcu/README.md

@@ -19,13 +19,13 @@ The connector used for power and control is a GX16-8 style round connector as sp
 ### Required Hardware
 
 * M3x4x5mm or M3x6x5mm threaded inserts, qty 4, to secure lid to base.
-* M3x??? socket head cap screws, qty 4, to secure lid to base.
+* M3x10 socket head cap screws, qty 4, to secure lid to base.
 * M4x16 flat head or button head screws and M4 nylon lock nuts, qty 6 each, to secure RFID pocket to front of enclosure.
 * M2.5x6 flat head screws, qty 10
   * 2 each to mount RFID reader to standoffs.
   * 4 each to mount ESP32 carrier board to standoffs.
   * 4 each to mount relay board to standoffs.
-* M2.5x??? flat head screws, 4 each, to mount LCD board to standoffs.
+* M2.5x4 or M2.5x5 flat head screws, 4 each, to mount LCD board to standoffs.
 * If using mounting holes, M4 hardware as described below.
 * Adhesive or hot glue, to mount the Neopixel status LED and (if needed) seal around the LCD display.