The issue of slower generation speeds when using the 4090 with this plugin on a Linux system.

[siji444]

Hello, author. Thank you very much for your contribution.
I installed this plugin after the latest ComfyUI from the official Comfy GitHub. It originally took only 3.5 seconds to run the XL model at a resolution of 1024.
After loading this plugin, the running time increased to 9 seconds. I have tried reinstalling with environments like 2.4.1+cu12.4, but it didn't resolve the issue. I hope to get some help.
I am using the 22.04 version of Linux and a conda environment.

                                                                                                                                                                                              Thank you.

[ltdrdata]

Is it correct that you're using the latest version of Impact Pack?
V7.10.6 is the latest version.

The issue where the ultralytics module was causing unnecessary performance degradation in older versions has been patched.

[siji444]

您使用的是最新版本的 Impact Pack 是否正确？ V7.10.6 是最新版本。

ultralytics 模块在旧版本中导致不必要性能下降的问题已得到修补。

I'm very sorry; I should be using the latest version.
It should have loaded correctly, but after nearly a week of various reinstallations, I still can't resolve it. I'm not sure if it's a system @ltdrdata

[siji444]

您使用的是最新版本的 Impact Pack 是否正确？ V7.10.6 是最新版本。
ultralytics 模块在旧版本中导致不必要性能下降的问题已得到修补。

我非常抱歉;我应该使用最新版本。它应该已经正确加载，但经过近一周的各种重新安装，我仍然无法解决它。我不确定这是否是一个系统

The latest test shows that the flux speed is normal, but there is a significant slowdown when running 1.5 and XL.