PLAY of file on SD gets response from Marlin "open failed"

[3D-Darryl]

Selecting "Play" on cal.gcode (on the Ai Thinker SD) sends "M23 /cal.gcode" then "M24" and gets response "open failed, File:cal.gcode". This would work for files on the Printer's SD but could never work for files on the ESP32 SD.

The same file "cal.gcode" can be printed from the printer's LCD panel.

To Reproduce
put a valid gcode file on the ESP32 SD card
View the file list on the web page
select the "play" button

Expected behavior
The ESP32 should stream the file from the ESP32 SD to the Marlin firmware similar to Octoprint.

ESP3D Firmware: (please complete the following information)
WebUI 3.0.0-a31.M2.1
FW Version 3.0.0.a225

Target Firmware: (please complete the following information)
Marlin 2.1.2

Board used (please complete the following information):
ESP32 AI-Thinker with camera and SD card. 32GB SD formatted FAT32.
Flash and SD and TFT-SD enabled. Global file system enabled.

Browser used (please complete the following information):
Firefox

• Version [e.g. 2.0]
• Operating system [e.g. Windows 10]

Additional context
Add any other context about the problem here.
Developer tools output, error message, etc...

[luc-github]

I already answered #347 (comment)

the stream status is here luc-github/ESP3D#243

Close as duplicate of luc-github/ESP3D#243

[github-actions]

This issue has been automatically locked since there has not been any recent activity after it was closed. Please open a new issue for related bugs.