logging?

[bdag]

Hey, just installed and when running:
onkyo --discover

I get not response. Furthermore, when running:
onkyo system-power=off

I get the following:
No receivers found.

Is there a place to see errors?

[travnick]

To execute commands, you need to pass a device address like:
onkyo --host my-onkyo.local zone2.power=off
onkyo --host 192.168.1.100 zone2.power=off
Where of course my-onkyo.local or 192.168.1.100 ip address match your setup.

Unfortunately, the --discover does not work for me too.

There are related issues without solution for this #99, #100, #103

--- edit
Finally! The solution for discover option (in my case) was to accept incoming UDP traffic with source port 60128 (since destination is the same as the source port of sending the discovery packet) in firewall