Behringer Cmd Dv 1

Berhinger CMD DV-1

Hardware

This device is composed by endless encoders (Not specified by the officials specifications) sending two states position.
LEDs cannot be turned off or dimmed and are lighting in orange by default. They can be set in two other modes : blue or blinking blue.
The FX[1-4],Focus,Master,Double buttons are builtin controls used as a "shift" function and will only changes the addresses of their affected controls (knobs for FX[1-4], decks for others).

Mapping Description

The following description mapping is for a community mapping that you can find in the forums here

FX Layers

As there's twice the same controls for effects, they both are affected in exactly the same configuration and this to allow the mixing of effects between two tracks (different decks) at same time.

Dual FX Rack

Encoder	Effect Selection	Effect Parameter 1	Effect Parameter 2	Effect Parameter 3
Button	Enable/Disable Effect 1	Channel ouptu Deck 1	Channel output Deck 2	Channel output Master
Label	[ON/SEL]	[ 1 ]	[ 2 ]	[ 3 ]

• [ON/SEL] LEDs buttons are blinking blue when no effect is selected, turns into fixed blue when the effect unit is enabled and into fixed orange if disabled.
• [ 1 ] / [ 2 ] / [ 3 ] LEDs buttons are fixed blue if the desired channel is enabled and orange if disabled.

Special FX Rack

Theses are located above the deck buttons [A-D] :

Quick effect Pitch Adjust Channel 1	Quick effect Super Knob Channel 1	Quick effect Super Knob Channel 2	Quick effect Pitch Adjust Channel 2

Modes & Deck Selection

Mode is switched automatically after select one or more deck.

A,B,C,D :

• Select or deselect a deck for the mode operations
• LEDs are blinking blue when selected and orange if not.

Focus :

• Allow to set hotcues on selected decks

Master :

• Enable temporary beat rolls looping with ratios [1/16], [1/8], [1/4] and [1/2]
• Allow to activate hotcues on selected decks

Double :

• Enable temporary beat rolls looping with ratios [1], [4], [8] and [16]

:!: Important : Switching mode will always require to redo deck selection.

Others functions

Erase :

• Allow to remove hotcues after selecting deck(s)