Behringer Cmd Dv 1

Berhinger CMD DV-1

Manufacturer's product page : Behringer

Hardware

This device is composed by endless encoders (Not specified by the officials specifications) sending two states position and momentary push buttons. Its LEDs cannot be turned off and are lighting in orange by default. They can be set in two modes : blue or blinking blue.
The FX[1-4],Focus,Master,Double buttons are builtin controls used as a "shift" function and will only changes the addresses of their affected controls (knobs for FX[1-4], decks for others).

LEDs Brightness

There is two levels for the brightness of the LEDs equipped on the CMD Series :

• Dimmed
• Bright (Max :?:)

Toggling between them can simply be done by pressing the four bottom buttons of the controller at same time and this can be done anytime while the device is running (plugged to power via USB).

Source : Resolume forum

:?: Controller also going into another mode (need to be defined) when pressing the same buttons but while plugging the controller : this one show buttons LEDs [ 7 ]&[ 8 ] dimmed and buttons LEDs [ 3 ]&[ 4 ] in bright mode.

Mapping Description

The following description mapping is for a community mapping that you can find in the forums here

FX Rows

The first two rows of encoders and the row of buttons above & below each of them control effects.

Dual FX Rack

Encoder	Effect Selection	Effect Parameter 1	Effect Parameter 2	Effect Parameter 3
Button	Enable/Disable Effect 1	Channel output Deck 1	Channel output Deck 2	Channel output Master
Label	[ON/SEL]	[ 1 ]	[ 2 ]	[ 3 ]

• [ON/SEL] LEDs buttons are blinking blue when no effect is selected, turns into fixed blue when the effect unit is enabled and into fixed orange if disabled.
• [ 1 ] / [ 2 ] / [ 3 ] LEDs buttons are fixed blue if the desired channel is enabled and orange if disabled.

Special FX Rack

Theses are located above the deck buttons [A-D] :

Quick effect Pitch Adjust Channel 1	Quick effect Super Knob Channel 1	Quick effect Super Knob Channel 2	Quick effect Pitch Adjust Channel 2

Modes & Deck Selection

Mode is switched automatically after select one or more deck.

A,B,C,D :

• Select or deselect a deck for the mode operations
• LEDs are blinking blue when selected and orange if not.

Focus :

• Allow to set hotcues on selected decks

Master :

• Enable temporary beat rolls looping with ratios [1/16], [1/8], [1/4] and [1/2]
• Allow to activate hotcues on selected decks

Double :

• Enable temporary beat rolls looping with ratios [1], [4], [8] and [16]

:!: Important : Switching mode will always require to redo deck selection.

Others functions

Erase :

• Allow to remove hotcues after selecting deck(s) (Only available in Focus and Master modes)

Slice :

• Not assigned yet

Store :

• Not assigned yet

Phrase :

• Not assigned yet