-
|
Earlier today i converted my pico_ADC input to the ads1115 board its all setup and working in the pinscape pico config tool and i've calibrated it, it was working just fine with the pico_ADC but now that I've switched over everything works in vpx but the plunger, it should still be the z axis but i'm not getting any plunge at all now. not even a wiggle I'm missing some step here just can't figure out what it is. |
Beta Was this translation helpful? Give feedback.
Replies: 1 comment
-
scratch that, my calibration never stuck so it wasnt calibrated its all good. |
Beta Was this translation helpful? Give feedback.
scratch that, my calibration never stuck so it wasnt calibrated its all good.