You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
When working with git master branch, or 3.22.2, QGIS Azimuth and Distance plugin seems to add a constant offset to the azimuths entered.
I am working with CRS EPSG:22717 NAD83(CSRS) epoch 2010 for both project and point layer. I add to Active layer, using Survey type Boundary, Angle type azimuth or bearing, Distance unit Default, Angle unit Degree, North type Default.
I choose a point on the map, and create a segment 100m Azimuth 0, then Draw.
If i use the measure bearing tool, i get around 0.32 degrees, and it seems to vary slightly each time i draw from a different starting point, but if I delete the drawn, point and snap to the same starting point, i get the same offset.
The text was updated successfully, but these errors were encountered:
When working with git master branch, or 3.22.2, QGIS Azimuth and Distance plugin seems to add a constant offset to the azimuths entered.
I am working with CRS EPSG:22717 NAD83(CSRS) epoch 2010 for both project and point layer. I add to Active layer, using Survey type Boundary, Angle type azimuth or bearing, Distance unit Default, Angle unit Degree, North type Default.
I choose a point on the map, and create a segment 100m Azimuth 0, then Draw.
If i use the measure bearing tool, i get around 0.32 degrees, and it seems to vary slightly each time i draw from a different starting point, but if I delete the drawn, point and snap to the same starting point, i get the same offset.
The text was updated successfully, but these errors were encountered: