Using a default.pa Causes PulseAudio to not Launch

[Dracrius]

I am attempting to setup PulseAudio to be a sink for my OpenHAB home automation server. (https://www.openhab.org/addons/bindings/pulseaudio/) but I'm running into a lot of issues. Firstly the windows build from the PulseAudio website will connect beautifully just by adding load-module module-cli-protocol-tcp to the default.pa and passing that in as a launch command but the audio received was being played way to fast so I tried to find a support page and I ended up on the Element chat room where no one knows anything about the windows builds haha but one guy found your site and I decided to start trying it instead but now I get a whole new set of issues.

If I enable the use default.pa or use a default.pa as a launch command I get a too many commands error and the server just wont start. I can not see any rhyme or reason to this either. If I disable it again and simply try to edit the system.pa I can get it workingish I'll post a different issue for those problems.