Perform Auto Z at KAMP Center

[Dylan144GT]

Hi,

Is it possible to add a feature where the auto z is performed in the center of the KAMP zone rather than in the middle of the bed. This is because it is good practice to print in different areas of the bed to ensure even wear, but the variance of the bed may be different in different KAMP zones.

Personally I find I need to adjust the z-offset whenever I don't print in the middle of the bed. One can argue that I don't have a flat bed, but I don't think that I am the only one in this position, especially on the more budget printers.

Thanks,

Dylan

[TitusLabs]

Sorry, I don't use KAMP. But you can use the BED_POSITION parameter of the Z_CALIBRATION command. Would that be enough?