Control an external LCD during Circle boot.

[Newdrake]

I would like to know if it is possible to modify the original circle boot code, that is the code that produces the rainbow color on the HDMI screen, to turn on an external LCD connected to the GPIO.
I ask this because in our application we have to wait about 10 seconds before seeing the LCD start writing something.
Is it possible to have this source code to insert the LCD activation?

Thanks a lot for your support!

[rsta2]

The rainbow screen is displayed by the firmware. It can be switched off, but not replaced. I think you can expect a GPIO-connected LCD display to display something after about two seconds, after Circle gets control from the firmware. The initialization of the member classes of CKernel must be reordered for this purpose. May I ask, what type of LCD display is it?

[Newdrake]

In my circle application I saw this timing, approximately:

0:00 Power on
5:46 Rainbow screen
8:96 Logger: Circle 44.2 ..
10:65 LCD on
Do you think this can be improved?

[rsta2]

The rainbow screen can be switched of with disable_splash=1 in config.txt. Also force_eeprom_read=0 and disable_poe_fan=1 may help to reduce the boot time. See this for more info.

Do you mean the CSPIMaster driver with SPIO? If so you should move the CSPIMaster to the first position in the list of member objects in CKernel and your LCD driver to the second. Then initialize the SPI master first and your LCD display second. You should be able to write to it then. In any case initialize the USBHCI member, the EMMC driver and the multi-core support after your display.

I did not expect these times. There is not much room for improvements between power on and 8:96 (see above). You also can use the cutdown firmware with gpu_mem=16 in config.txt and compress your kernel image with GZIP_KERNEL=1 in Config.mk (before build). But the firmware needs some time to tune the SDRAM timings. I think this takes most of the boot time.

[Newdrake]

Tanks a lot for this suggestion, I'll try all of these and let you know after how much time reduction I obtain,
Regards.

[Newdrake]

After many test and try to use the maximum number of boot time reduction parameter, I obtain a gain of about 2:20s, not bad.
This is the list of used switch:
initial_turbo=15
disable_splash=1
force_eeprom_read=0
disable_poe_fan=1
gpu_mem=16
ignore_lcd=1
disable_touchscreen=1
disable_fw_kms_setup=1
camera_auto_detect=0
display_auto_detect=0
enable_uart=0

So finally I obtain:
6:75s Logger: Circle 44.2 ..

Do you know a switch/variable to force the boot device or the image file? Without searching around devices like eporm, EMMC, ..

Thanks a lot again!!

[rsta2]

Not bad! The boot configuration on the CM4 can be changed like that. You are welcome.