Print Width

[MrDixioner]

Where are the Bridge Print Thickness settings and why are Padding and Top Padding printed at a different width than what I set?

In Pryusha Slicer there is a parameter for the width of the extrusion of the bridge, as well as a parameter responsible for the flow of the bridge. There are no such parameters in the SuperSlicer and the width of the bridge extrusion is not clear how it is calculated.

Also in PryushaSlicer, the Fill and Top fill extrusion width parameters are printed exactly the same way as I set them. In SuperSlicer, the calculation of these parameters is not clear and differs from those that I have set.