You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
In Width&Flow settings if you set the "Flow ratio above the bridges" to a value different than 100%, for example 105%, then the "Solid infill spacing" you have set (for example 0.6mm) is ignored, and a default value (probably the nozzle width, 0.4mm in my case) is applied. This default value is only applied to the first solid infill layer above the internal bridge over the sparse infill. The following solid infill layers have the correct spacing, so the bug is certainly due the code managing the flow ratio above the (internal) bridges.
What happened?
In Width&Flow settings if you set the "Flow ratio above the bridges" to a value different than 100%, for example 105%, then the "Solid infill spacing" you have set (for example 0.6mm) is ignored, and a default value (probably the nozzle width, 0.4mm in my case) is applied. This default value is only applied to the first solid infill layer above the internal bridge over the sparse infill. The following solid infill layers have the correct spacing, so the bug is certainly due the code managing the flow ratio above the (internal) bridges.
Project file & How to reproduce
SolidInfillSpacingBug.zip
Version
2.5.59.13 (the latest as of today)
Operating system
Windows 10
Printer model
Flying Bear Reborn 2
The text was updated successfully, but these errors were encountered: