Replies: 3 comments 1 reply
-
Was that from this issue: rstrouse/nodejs-poolController-dashPanel#52? Can you re-upload a packet capture so we can see your latest config? And just to clarify, you want the main pool's spa circuit to set the chlorinator to 100% on the 'remote' system? And should it be off or some other % when the circuit is off? |
Beta Was this translation helpful? Give feedback.
-
I'm talking about this one: rstrouse/nodejs-poolController-dashPanel#53. I lost this when I went back to a single njsPC instance. And yes, this is exactly what I want. 100% is fine. I think you did the first time using the heat on/off virtual circuit as the heat is always turned on when Spa is on. |
Beta Was this translation helpful? Give feedback.
-
Sorry I've been away for a few days. So, this should go in the
controllers' config.json? Under integrations like last time? Thanks!
…On Thu, Jun 23, 2022 at 12:45 PM tagyoureit ***@***.***> wrote:
You should be able to use the same exact logic... just change the host to
'localhost' (or an ip) and double check the id's for the two chlorinators.
{
"context": {
"name": "njsPCAux",
"options": {
"method": "POST",
"path": "/",
"headers": {
"CONTENT-TYPE": "application/json"
}
},
"vars": {}
},
"events": [
{
"name": "virtualCircuit",
"description": "Set the superchlor when the spa heater turns on or off",
"body": ***@***.***={id:1, isDosing: data.isOn};",
"enabled": true,
"options": {
"host": "localhost",
"port": 4200,
"method": "PUT",
"path": "/config/chlorinator"
},
"filter": ***@***.***=data.id === 245;"
}
]
}
When the spa heater (245) changes, set the chlorinator to dose. Give it a
shot.
—
Reply to this email directly, view it on GitHub
<#500 (reply in thread)>,
or unsubscribe
<https://github.com/notifications/unsubscribe-auth/AV2HSS6JSU55STAGDJPT6JDVQSWEDANCNFSM5ZSO5M6A>
.
You are receiving this because you authored the thread.Message ID:
<tagyoureit/nodejs-poolController/repo-discussions/500/comments/3012759@
github.com>
|
Beta Was this translation helpful? Give feedback.
-
@rstrouse Hi. Remember that at some point you helped me to add a special behavior so that when I turn on the spa circuit the Intellichlor would go to 100%? I lost that behavior when I went from having an additional Nixie controller operating my aux RS485 controller to directly incorporating the aux controller into my main instance. Any way I can set that behavior again under the new setup? Many thanks!
Beta Was this translation helpful? Give feedback.
All reactions