Whisperflo VST? #778
Unanswered
jreising326
asked this question in
RS485
Replies: 2 comments 4 replies
-
The rumor is that this pump communicates using the same protocol as the IntelliFlo VS. I also believe there are others that have this pump working with njsPC. Are you certain you have addressed the pump correctly. You should verify the yellow/green wires are connected to RS485 A/B correctly. |
Beta Was this translation helpful? Give feedback.
1 reply
-
I have the same pump, use the Pentair cable and an USB dongle. I can't even get a serial tool such as SerialTools or SerialMonster show the incoming data from the pump. What settings do you use on the Pump? Thanks for your help. |
Beta Was this translation helpful? Give feedback.
3 replies
Sign up for free
to join this conversation on GitHub.
Already have an account?
Sign in to comment
-
Newbie with new Pump and new njsPC install. Using the RS485 Dongle and Pentair Cable, for now just trying to get the Pump to turn on. I have it configured in Dashpanel as Intelliflo VS and am getting setPumpRPMAsync errors. Just focusing on getting the pump to run and make sure it's wired up and configured correctly, and to make sure this pump is actually supported. I have 3 speeds setup as Features, I get no errors when I set the speed to zero/turn off the pump, so I think it is communicating OK. Pump says it's in Auto Mode and is setup for "Direct Control". Any and all advice is appreciated! I saw a few posts discussion the differences but didn't see anything confirming someone has this working with the Whisperflow VST. Any advice or info is appreciated. Thanks, Joe
Beta Was this translation helpful? Give feedback.
All reactions