Not working with MSI 2080 Trios X

[davidm71]

Hi,

Here is the dxe driver configuration info:

isDirty: 0
OptionFlags: 0x02
nPciBarSize: 0
nGPUSelectorCount: 1
GPUSelector1: deviceID: 1E87
GPUSelector1: subsysVendorID: FFFF
GPUSelector1: subsysDeviceID: FFFF
GPUSelector1: bus: FF
GPUSelector1: device: FF
GPUSelector1: function: FF
GPUSelector1: barSizeSelector: 9
GPUSelector1: overridebarSizeMask: 0

    nGPUConfigCount:   1
            GPUConfig1:    deviceID:        1E87
            GPUConfig1:    subsysVendorID:  1462
            GPUConfig1:    subsysDeviceID:  3726
            GPUConfig1:    bus:             03
            GPUConfig1:    device:          00
            GPUConfig1:    function:        0
            GPUConfig1:    BAR0 base:       0xFA00'0000
            GPUConfig1:    BAR0 top:        0xFAFF'FFFF

    nBridgeCount:      1
            BridgeConfig1: vendorID:        8086
            BridgeConfig1: deviceID:        6F08
            BridgeConfig1: bus:             00
            BridgeConfig1: device:          03
            BridgeConfig1: function:        0
            BridgeConfig1: secondary bus:   03

System

• Motherboard: MSI X99A Godlike
• BIOS Version: 1A
• GPU: MSI 2080 Trios X
• [x ] CSM is turned off. Make sure to confirm this in the BIOS and not with GPU-Z or similar since it can be inaccurate
• [x ] 4G decoding is enabled. Make sure to confirm this in the BIOS and not with GPU-Z or similar since it can be inaccurate
• UEFIPatch is applied (see Using UEFIPatch for more information). On some motherboards DSDT Patching is also needed
• [ x] I have read Common issues (and fixes)

Description

The issue is that I can't get it activated. Installed the FFS file via UEFITool and updated the bios with M-Flash.
How can I tell that the module is loaded and is working as I can not see via gpu-z that it is at all.

Thank you

[mvildosolae]

What's the output of NvStrapsReBar.exe? I have an RTX 2060 (so same Turing arch as your card), and I could enable it through the EXE. Note that flashing the modded BIOS/UEFI is not enough, you need to use the EXE to enable ReBar.