A large LCD touchscreen for OctoScreen or OctoDash.
All required parts are listed below. Supplier examples are provided for convenience.
Additional Non-Stock Parts:
Qty | Description | Supplier Links |
---|---|---|
1 | Adafruit PiTFT Plus 3.2 Touchscreen | Adafruit |
1 | M2.5 x 3.0 mm Heat Set Inserts | Alliexpress, McMaster Carr |
1 | M3 x 50 mm SHCS | Alliexpress, Bolt Depot |
4 | M2.5 x 10 mm BHCS | Alliexpress |
1 | 40-pin IDE Extension Cable | Amazon |
Repurposed Stock Parts:
Qty | Description | Supplier Links |
---|---|---|
12 | M3 x 8 mm BHCS | Alliexpress, Bolt Depot |
12 | M3 Makerbeam 1515 T Slot Nuts | Alliexpress, Amazon |
4 | Rubber Feet (14 x 11 x 9) | Alliexpress |
Qty | Description | STL Slicer Image |
---|---|---|
2 | Skirt Side A | |
2 | Skirt Side B | |
1 | Skirt Front Left | |
1 | Skirt Front Right | |
1 | LCD Mounting Bracket | |
1 | LCD Face Plate | |
2 | Foot Front | |
2 | Foot Rear |
All 3D Parts can be printed without support material: ABS, 0.4 mm nozzle, and 0.2mm layers.
- Install 4 M2.5 heat set inserts into
LCD Mounting Bracket
- Remove the stock V0 skirt and feet.
- Install extended feet with 50mm M3 SHCS.
- Install all
Side Skirt A/B
parts using the stock mounting T-nuts and M3 x 8 screws. - Install the
LCD Mounting Bracket
using the middle two T-nuts on the front extrusion. - Install
Front Skirt Left/Right
using the remaining two T-nuts on each side of the LCD. - Connect the 40-pin ribbon cable to the
Adafruit PiTFT Plus
. - Place the
Adafruit PiTFT Plus
into theLCD Face Plate
. - Route the ribbon cable through
LCD Mounting Bracket
to Raspberry Pi. - Secure
LCD Face Plate
with four M2.5 x 10 screws.
Follow the Adafruit LCD Installation Instructions.
The 3.2" LCD is pin-equivalent to the 2.8" LCD. You can safely follow the same instructions.
The recommended installation type is fbcp
, framebuffer copy:
sudo python3 adafruit-pitft.py --display=28r --rotation=90 --install-type=fbcp
The fbcp
option causes the X11 output to be mirrored on the PiTFT display.