bt_dedsec is a bluetooth hacking device/tool using (esp32 nodemcu and esp-prog) can perform dos attack on any bluetooth device like bluetooth speaker,smartphone,IoT device, etc. using BRAKTOOTH exploit
Braktooth is a collection of flaws affecting commercial bluetooth stacks on more than 1,400 chipsets used in billions of devices - including smartphones, PCs, toys, speakers, internet of things(Iot) devices and industrial equipment - that rely on bluetooth Classic (BT) for communication
ESP32-devkit v1 nodeMCU
ESP-prog
Jumper wire female-female (8pcs)
Data usb cable
Ubuntu 18.04
VMWare
USB 3.0 port
Open VMWare and USB 3.0 enabled. We recommend Ubuntu 18.04
- git clone https://github.com/0xbitx/DEDSEC-Bluetooth-exploit.git
- cd DEDSEC-Bluetooth-exploit
- sudo apt install unzip python3-dev
- tar -xzvf braktooth.tar.gz
- cd braktooth
- sudo ./requirements.sh
- connect esp32 nodeMCU via usb cable to your pc
- sudo esptool.py erase_flash (boot button maintained)
- connect the esp32 nodemcu and esp-prog
----------------------------------------
no. Esp-prog Esp32
----------------------------------------
1. GND - GND
2. 3.3v - 3.3v
JTAG
3. TMS - gpio14
4. TCK - gpio13
5. TDO - gpio15
6. TDI - gpio12
SERIAL
7. TX - TX
8. RX - RX
----------------------------------------
- connect esp-prog via usb cable to your pc
- cd firmware
- sudo python3 firmware.py flash /dev/ttyUSB1 (check your esp prog path | command: ls /dev/ttyUSB* )
- then hold the BOOT button on (esp32 nodemcu) - dont forget to press RESET button afterwards
sudo ./dedsec_braktooth_cli
datasheet for ESP32 NODEMCU
datasheet for ESP32 PROG