Merge branch 'main' of https://github.com/Architeuthis-Flux/Jumperless

Probe_Guide.md

@@ -0,0 +1,36 @@
+# Probe Kit Assembly Guide
+![probePCB copy](https://github.com/user-attachments/assets/ac8bf8a3-5925-482b-8a0c-045cf857685b)
+
+
+Square holes connect to the Probe 
+Round holes connect to the Button 
+![pobeCircuit](https://github.com/user-attachments/assets/14849a79-7de1-4cee-9ee5-20d73590c264)
+
+Lift the middle tab and solder your favorite button facing 
+down so it can be pressed by pushing on the bar (pro tip:
+stick something in there to keep it down while soldering)
+
+Break off that triangular tab at the end and solder 
+it to the end of the wires that connect to the Jumperless. 
+The 2mm pitch header pins should friction fit into the 
+2.54mm spaced holes 18 and 19 at the top left corner.
+![probePCB copy](https://github.com/user-attachments/assets/074b590f-71d9-4b72-abf1-19dede25eba1)
+
+Strip the single wire wrap wire (you can use your fingernails)
+and lace it through the holes around the needle tip, then 
+slide the needle under it and flood the whole pad with solder
+![probePCB copylaceNeedle](https://github.com/user-attachments/assets/12e67f86-bd8d-4c0d-acf6-6764eae8489c)
+
+
+
+Remember to bridge those pill-shaped pads with a tiny dot 
+of solder at the end of the rows connecting to your button.
+![JumperlessProbe2](https://github.com/user-attachments/assets/ab38888e-b2ed-4f44-a5d4-00dc7dd7c433)
+
+If pressing the button puts the Jumperless in probe mode
+but doesn’t light the LED or sense rows, the Button and 
+Probe connections are swapped, just turn the connector around.
+
+
+Or just have fun with it and do it however the hell you want!
+I’m a piece of paper, not a cop.

README.md

@@ -16,6 +16,10 @@ Using a bunch of analog crosspoint switches wired together into one bigger switc
 ![BreaboardJump00420](https://github.com/Architeuthis-Flux/Jumperless/assets/20519442/c3ec1f73-97c5-4268-9da4-672787bc9e1a)
 
 
+#### [3D Printable Stand](https://www.printables.com/model/684090-stand-for-the-jumperless-breadboard) (you can drop the model through the build plate to adjust the height)
+
+#### [3D Printable Jumperless Trap](https://www.printables.com/model/1040448-jumperless-v1-3-case) (jk it's a carrying case, but make sure you can get it back open before you put your Jumperless in it)
+
 
 
 Try this Wokwi project if something isn't working: https://wokwi.com/projects/389569655762010113