Skip to content

A low pin count sniffer for ICEStick - targeting TPM chips

License

Notifications You must be signed in to change notification settings

Are-s-h/lpc_sniffer_tpm

 
 

Repository files navigation

TPM Specific lpc sniffer (low pin count) for ice40 stick

Turn the ice40 stick into a LPC sniffer, only logging TPM specific messages. This repository is a duplicate of https://github.com/lynxis/lpc_sniffer/, with modifications made to only log messages with start field 0101 and address between 24 and 27.

This project was used to extract BitLocker VMK keys by sniffing the LPC bus when BitLocker was enabled in it's default configuration. More information is available in this post.

features

  • i/o read + writes
  • memory read + writes
  • sync errors

How to use

  1. modify EEPROM of the FTDI and enable OPTO mode on Channel B
  2. program lpc_sniffer.bin into your ice40 by iceprog lpc_sniffer.bin
  3. note: previous command can be replace by make install
  4. connect the LPC bus
  5. extract LPC data: python3 ./parse/read_serial.py /dev/ttyUSB1 | tee outlog
  6. extract key from data: cut -f 2 -d' outlog | grep '2...00$' | perl -pe 's/.{8}(..)..\n/$1/' | grep -Po "2c0000000100000003200000(..){32}"

what connectors are used on the IceStick?

  • J1 connector
	VCC 3.3|NC 1
	GND        2
	lpc_clock  3
	lpc_ad[0]  4
	lpc_ad[1]  5
	lpc_ad[2]  6
	lpc_ad[3]  7
	lpc_frame  8
	lpc_reset  9
  • uart output over the ftdi

LEDs

	For orientation: the usb port points south:
	green in the middle: overflow_led

overflow_led when internal buffer is full. No more LPC frames are decoded

Uart protocol

The LPC sniffer will write out frames onto the second uart of FTDI with 921600 baud.

format

  • 4 byte: address
  • 1 byte: data
  • 1 byte: 0-3bits: direction+type, 4-7: errorcode
  • 2 byte: '\r\n'

error codes

An error code is decoded in 4 bits

  • 0001 - sync timeout.

Internal documentation

A LPC frame will:

  1. decoded by the LPC decoder
  2. saved into the internal memory
  3. padded by \r\n
  4. written onto uart

in memory layout

The internal memory is used as 48bit addressable memory. 48 bit is exact one lpc frame

  • 4 byte: address
  • 1 byte: data
  • 1 byte: direction/type + error code

internal buffer

The LPC sniffer is using an internal buffer. When the internal buffer is full, new frames will be discarded. The green LED in the middle will turn on. The internal buffer can save up to 2**10 lpc frames (1024).

About

A low pin count sniffer for ICEStick - targeting TPM chips

Resources

License

Stars

Watchers

Forks

Releases

No releases published

Packages

No packages published

Languages

  • Verilog 87.8%
  • Makefile 7.1%
  • Python 5.1%