Welcome abroad AIoT Enthusiast!
In this repository you'll get Embedded System Tutorial, ranging from topics:
- Chapter 0 : Installation (SimulIDE / WokWi / Using Arduino Directly
- Chapter 1 : GPIO Introduction using Arduino Uno
- Chapter 2 : Finite State Machine (FSM)
- Chapter 3 : Low Power Aplication in Arduino Uno
- Chapter 4 : RTOS
- Chapter 5 : Fault Tolerant System using Watchdog Timer
- Using simulation a. You can choose software simulation you want either SimulIDE / WokWi
- Directly using Arduino
In order to try it directly you need to have:
- a. Breadboard MB102 or its size (1x)
- b. LED (6x)
- c. Arduino Uno (1x)
- d. Breadboard Power Supply (1x)
- e. Multimeter (1x)
- f. Resistor 220 ohm (6x)
- g. Push button (3x)
- h. Cable Jumper M-M (40 ways)
- j. Power Supply adapter Arduino Uno (1x)
You can start learning by following this step:
- Learn the theory from Slide / Module
- Excersise the test within the module
- Make sure you answer the question wihtin the module first before looking the answer at debug folder
Robotics and Embedded System Laboratory Faculty of Computer Science Universitas Brawijaya