Python script to be run the octopi. Will automatically connect to the HUB and activate it, providing the information needed to communicate back. ###Preinstallation ####Octopi This api relies on Octopi and assumes you have some knowledge of it. Please visit https://github.com/guysoft/OctoPi for information on Octopi. Before installing this software you must have set up a default slicing and printer profile, along with the API-Key. ###Installation ####Requirements Must be installed on a debian based distro, ie. raspbian, ubuntu ####Instructions #####Interface The interface to use for connecting to the HUB. This will most likely be your wireless adapter, ie. wlan0 #####Config file The file to write command line configuration to. Default is recommended #####Network SSID The SSID of the Wireless Access Point that the HUB will be broadcasting. #####Network Password The password of the Wireless Access Point. #####Black Box UID The UID of the blackbox that the printerpi and printer should be plugged into. #####IP Address The IP Address of the HUB's webserver #####Port The Port of the HUB's webserver
-
Notifications
You must be signed in to change notification settings - Fork 0
StratusPrint/printerpi_boot_script
This commit does not belong to any branch on this repository, and may belong to a fork outside of the repository.
Folders and files
Name | Name | Last commit message | Last commit date | |
---|---|---|---|---|
Repository files navigation
About
Python script to be run the octopi. Will automatically connect to the HUB and activate it, providing the information needed to communicate back.
Resources
Stars
Watchers
Forks
Releases
No releases published
Packages 0
No packages published