Skip to content

Announce domains captured from DNSTap over BGP

License

Notifications You must be signed in to change notification settings

adipierro/dnstap-bgp

 
 

Repository files navigation

Go Report Card Coverage Status Build Status

dnstap-bgp

Overview

This daemon was created to solve the problem of manipulating traffic based on domain names instead of IP addresses. It does this by intercepting DNS replies and exporting the resolved IPs using BGP protocol. The BGP peers can then use this information to influence the traffic flow.

Workflow

  • Client sends DNS request to a recursive DNS server which supports DNSTap (unbound, bind etc)
  • DNS server logs the reply information through DNSTap to dnstap-bgp
  • dnstap-bgp caches the IPs from the reply and announces them through BGP
  • When the request for the already cached IP comes again - refresh its TTL

Features

  • Load a list of domains to intercept: the prefix tree is used to match subdomains
  • Hot-reload of the domain list by a HUP signal
  • Full support for IPv6 (I hope): in DNS (AAAA RRs), in BGP and in syncer
  • Support for CNAMEs - they are resolved and stored as separate ip -> domain entries
  • Export routes to any number of BGP peers
  • Configurable timeout to purge entries from the cache
  • Persist the cache on disk (in a Bolt database)
  • Sync the obtained IPs with other instances of dnstap-bgp
  • Can switch itself to a pre-created network namespace before initializing network. This can be useful if you want to peer with a BGP server running on the same host (e.g. bird does not support peering with any of the local interfaces). This requires running as root.

Synchronization

dnstap-bgp can optionally push the obtained IPs to other dnstap-bgp instances. It also periodically syncs its cache with peers to keep it up-to-date in case of network outages. The interaction is done using simple HTTP queries and JSON.

Limitations

  • IDN (punycode) domain names are currenly not supported and are silently skipped
  • Sync is fetching the whole cache contents from peers, so if the lists are large (millions of entries) it can be hard on memory and network
  • Performance was not measured very much, but it should be quite scalable - the only single-threaded part is reading from DNSTap socket, but it should be very lightweight
  • The domain list and IP cache are stored in memory for performance reasons, so there should be enough RAM
  • Logs only to stdout for now

Installation

From packages

Get deb or rpm packages from the releases page.

From source

You'll need Go environment set up and dep installed, then just run make

Building packages

To build a package you'll need fpm tool installed, then just run make rpm or make deb

Configuration

See deploy/dnstap-bgp.conf for an example configuration and description of parameters.

DNS server examples

DNSTap protocol works in a client-server manner, where DNS server is the client and dnstap-bgp is a server.

Unbound

Unbound seem to be able to work with DNSTap only through UNIX sockets.

dnstap:
    dnstap-enable: yes
    dnstap-socket-path: "/tmp/dnstap.sock"
    dnstap-log-client-response-messages: yes

Important In Ubuntu access to the DNSTap socket for Unbound is blocked by default by AppArmor rules. Either disable it for the Unbound binary or fix the rules.

BIND

DNSTap is supported since 9.11, but usually is not built-in, at least in Ubuntu packages. BIND also can connect only using UNIX socket.

dnstap {
    client response;
};

dnstap-output unix "/tmp/dnstap.sock"

About

Announce domains captured from DNSTap over BGP

Resources

License

Stars

Watchers

Forks

Releases

No releases published

Packages

No packages published

Languages

  • Go 94.3%
  • Makefile 5.7%