I saw this awesome lamp on thingiverse here and thougt, that i need a sort of this lamp in my room. The only problem: I only have a 121212cm printing volume with my MPSM 2. So I printed the lamp with a high of just 61% and the LED Bar with a high of 11.5cm. Most of the parts were printe with transparent PLA, only the bottom of the body was printed with grey Filament.
The print worked awesome, I was surprised by the spiral mode, which worked perfectly and created thin walls all over the lamp cover. I had some problems with the bed adhesion like always, but I could perfectly work with the results.
As a controller I use the ESP32 with the WiFi module and the code section is in /https:...
As a lightstrip I use WS2812 and instead of just wrapping it once around the tower, I wrapped it twice around the middle circle.
Is planned
pip install foobarThe used 3D design was remixed by Thingiverse user splitbrain. Thingiverse and my design is just his version cutted/minimized.