Kircular Accelerator Prototype Innovative New Experience
Run the following command to install the third party KiCAD libraries used in the project
git submodule update --init --recursive
This project uses components from digikey-kicad-library which is configured as a git submodule of this project. Git doesn't clone submodules of a project by default when the project it is cloned so this has to be done manually.
Application Signal Descriptions
- m[0..15] -- Electromagnet control signals
- s[0..15] -- Photogate sensor input signals
- Debug 1 -- Debug led 1
- Debug 2 -- Debug led 2
- USART1 -- Command link UART
| Microcontroller Pin | Application Signal | Direction | Alternate Function |
|---|---|---|---|
| PB5 | m0 | Digital out | TBD |
| PD2 | m1 | Digital out | TBD |
| PC11 | m2 | Digital out | TBD |
| PA12 | m3 | Digital out | TBD |
| PA8 | m4 | Digital out | TBD |
| PC8 | m5 | Digital out | TBD |
| PC6 | m6 | Digital out | TBD |
| PB14 | m7 | Digital out | TBD |
| PB11 | m8 | Digital out | TBD |
| PB2 | m9 | Digital out | TBD |
| PC5 | m10 | Digital out | TBD |
| PA3 | m11 | Digital out | TBD |
| PC3 | m12 | Digital out | TBD |
| PC1 | m13 | Digital out | TBD |
| PB9 | m14 | Digital out | TBD |
| PB7 | m15 | Digital out | TBD |
| PB4 | s0 | Digital in | TBD |
| PC12 | s1 | Digital in | TBD |
| PC10 | s2 | Digital in | TBD |
| PA11 | s3 | Digital in | TBD |
| PC9 | s4 | Digital in | TBD |
| PC7 | s5 | Digital in | TBD |
| PB15 | s6 | Digital in | TBD |
| PB13 | s7 | Digital in | TBD |
| PB10 | s8 | Digital in | TBD |
| PB1 | s9 | Digital in | TBD |
| PC4 | s10 | Digital in | TBD |
| PA2 | s11 | Digital in | TBD |
| PC2 | s12 | Digital in | TBD |
| PC0 | s13 | Digital in | TBD |
| PB8 | s14 | Digital in | TBD |
| PB6 | s15 | Digital in | TBD |
| PA0 | Debug 1 | Digital out | TBD |
| PA1 | Debug 2 | Digital out | TBD |
| PA9 | USART1_TX | Digital out | AF7 |
| PA10 | USART1_RX | Digital in | AF7 |
| PC13 | RGB LEDs | Digital out | TBD |