esp32-at-via-bluetooth

A fork of espressif/esp32-at to support using AT command through Bluetooth SPP (Serial Port Profile).

Prerequisites

ESP-IDF is installed. ESP32-IDF v3.1.4 is strongly recommended.

Usage

1. Clone the project

git clone --recursive https://github.com/ev3rt-git/esp32-at-via-bluetooth.git

2. Connect the ESP32 board to your PC

3. Run make menuconfig in the project folder

In Serial flasher config, configure Default serial port for downloading
In Component config -> AT -> AT Bluetooth SPP settings, you can change the device name and PIN code

4. Run make flash monitor to build the project and run on the ESP32 board

In the output messages, you can see the MAC address for Bluetooth like:

BT Addr: 12:34:56:78:ab:cd

References

See ESP-IDF Get Started for ESP-IDF installation.
See espressif/esp32-at for other information about esp32-at.