Skip to content

Design an inverse kinematic controller to move end-effector. This work is done as a coursework for the 2nd semester of MAIA in Introduction to Robotics course.

Notifications You must be signed in to change notification settings

fitushar/Design-an-inverse-kinematic-controller-to-move-end-effector-

Repository files navigation

Design-an-inverse-kinematic-controller-to-move-end-effector-

Design an inverse kinematic controller to move end-effector. This work is done as a coursework for the 2nd semester of MAIA in Introduction to Robotics course.

Design an inverse kinematic controller to move end-effector. This work is done as a coursework for the 2nd semester of MAIA in Introduction to Robotics course.

Presentation Intro The task was to design an Inverse Kinematic controller to move the end-effector from the position pA to the position pB The movement should be repeated 3 times by control:

  • the position-only without exploiting the redundancy
  • the position and the orientation without exploiting the redundancy (desired orientation equal to the initial one)
  • the position and the orientation avoiding an obstacle put in p0 (desired orientation equal to the initial one)

Code folder Contains the all the implemented code with the GUI.

Presentation Intro Presentation Intro

About

Design an inverse kinematic controller to move end-effector. This work is done as a coursework for the 2nd semester of MAIA in Introduction to Robotics course.

Topics

Resources

Stars

Watchers

Forks

Releases

No releases published

Packages

No packages published