Adapter Configuration
- Technical name: Short description for the sawtooth (do not use blanks or similar in name). This name will be used in objects view
- Description: Description, just for better understanding.
After 1 minute the following objects would be created:
- currentValue = actual Value of the increment (could be written also, if readOnly was set to false)
- increment = the number will be added or removed (if less than 0) each run. One run is once a minute
- lastValue = for internal use, do not change it!
- maxValue = the maximum Value. currentValue wont go higher than that value
- minValue = the minimum Value, currentValue wont go lower than that value
- readOnly = if set to true, the currentValue could not be changed from outside, only from the adapter itself
- reset = if set to yes (or if pushed) the currentValue would be set to ether minValue or maxValue (as configured by resetMode)
- resetMode = configures if the currentValue should be set to minValue or maxValue as soon as reset was pushed