v1.18

• Battery charge is now tracked more precisely by Li-Po discharge voltage curve, no more full discharge for 1-2 hours.

v1.17

• Removed SSB persistent noize that was present even when volume is muted

Noize will be present when ATT in AUT mode, any other value will remove noize)

v1.16

• Fixed station scan could stuck on one station

v1.15

• Fixed a problem when last saved frequency for SW was overwritten by switching between subbands
• Added 3 sec timeout for Volume, Band, Bandwidth and Step adjustment modes
• Refactoring of command switch logic
• Removed Debug project config
• SW now starts from 1710 instead of 1700 KHz
• Some code improvements and minor bug fixes

v1.14

• Improved switching between SW subbands.
• No more misaligned frequencies on SW subbands.
• Fixed AM/FM station seek logic. Now can be stopped with Encoder rotation, AM seek step always match with selected step and FM seek step is always 0.1 MHz.
• Improved frequency tuning encoder response.
• Added 3 new minor settings (Disable Scan on encoder button, CW mode and Hide freq units). Also updated documentation.
• Fixed bugged limit of LW SSB.
• Improved EEPROM auto reset logic.
• Huge binary size optimization, code improvements.

v1.13

• Added BFO offset calibration feature

v1.12

• Fixed broken SSB bug when switching to SSB from AM with 6.0k bandwidth
• SSB Bandwidth is now stored independently from AM bandwidth
• Reduced binary image size for 62 bytes more

v1.11

• Reworked charge display logic
• Charge indicator will display --- on too low battery voltage
• Removed second FM band, now FM is just single full FM band from 64 to 108 MHz
• Some minor code improvements

v1.10

• Improved battery charge calculation
• Fixed charge is missing when USB is connected
• Fixed cutoff filter could be disabled in CW mode

v1.09

• Settings are now saved after closing Settings menu
• Fixed problems with EEPROM after first flash