Skip to content

About

No description, website, or topics provided.

Resources

Stars

0 stars

Watchers

0 watching

Forks

Latest commit

 

History

6 Commits

Folders and files

NameName
Last commit message
Last commit date
 
 
 
 
 
 

Repository files navigation

Dual-RFID Turnstile Access Control System

An Arduino-based access control controller that authenticates entry and exit RFID scans against a remote HTTP API in real time and actuates dual solenoid locks via a 2-channel relay module.

Overview

The system uses two MFRC522 RFID readers connected over SPI to handle bidirectional gate traffic (IN and OUT). When a card or tag is scanned, the microcontroller normalizes the UID bytes into an 8-digit decimal identifier and sends an HTTP GET request via an Ethernet Shield. Based on the server's single-character response (1 for authorized, 0 for denied), the controller triggers the corresponding solenoid relay and emits audible buzzer feedback.

Hardware Components

  • Microcontroller: 1x Arduino UNO
  • Networking: 1x Arduino UNO Ethernet Shield (W5100/W5500)
  • RFID Readers: 2x MFRC522 RFID Modules (13.56 MHz)
  • Actuation: 1x 2-Channel 5V Relay Module
  • Locks: 2x 12V Solenoid Door Locks (with external power supply)
  • Audio Feedback: 1x Piezo/Active Buzzer

Wiring & Pinout

Component Module Pin Arduino UNO Pin Notes
RFID Reader 1 (IN) SDA (SS) D5 Slave Select for Entry Reader
RFID Reader 1 (IN) RST D9 Reset pin
RFID Reader 2 (OUT) SDA (SS) D4 Slave Select for Exit Reader
RFID Reader 2 (OUT) RST D6 Reset pin
Shared SPI Bus MOSI / MISO / SCK D11 / D12 / D13 Shared between both MFRC522 readers and the Ethernet Shield (D10 reserved for Ethernet SS)
RFID Power 3.3V / GND 3.3V / GND MFRC522 operates at 3.3V logic/power
Relay Module IN1 (Entry Lock) A4 Configured as digital output
Relay Module IN2 (Exit Lock) A5 Configured as digital output
Buzzer + (Signal) D7 Audible status indicator

Buzzer Status Signals

Pattern Meaning
1 Beep System initialized and ready / Access granted (1)
2 Beeps Access denied (0)
3 Beeps Ethernet DHCP failure or server connection timeout

Setup & Configuration

1. Required Libraries

Install the following via the Arduino IDE Library Manager:

  • MFRC522 by GitHubCommunity / Miguel Balboa
  • SPI (built-in)
  • Ethernet (built-in)

2. Network & API Settings

Update the placeholder constants at the top of turnstile.ino before flashing:

const char SERVER_HOST[] = "access-control.example.com";
const char API_ENDPOINT[] = "/api/check_entry";
const char GATE_LOCATION[] = "gate_01";

About

No description, website, or topics provided.

Resources

Stars

0 stars

Watchers

0 watching

Forks

Releases

Packages

Contributors

Languages