Skip to content

This project aims to provide a very simple slow (~15KHz) but low noise photodiode front end, for the use in building scientific instrumentation.

License

Notifications You must be signed in to change notification settings

jproj3cts/Simple-Photodiode-Front-End

Folders and files

NameName
Last commit message
Last commit date

Latest commit

 

History

22 Commits
 
 
 
 
 
 
 
 

Repository files navigation

Simple-Photodiode-Front-End (Work in progress)

This project aims to provide a simple slow (~15KHz) but very cheap and low noise large area photodiode front end, for the use in building scientific instrumentation.

BILL OF MATERIALS

PBSS4360PA5-QX
TC1014-3.3VCT713
OPT101P-J
0805 Resistors
0805 Ceramic Capacitors
0805 Tantalum Capacitor (optional)

Circuit Design

The general scheme of this device is shown below. As can be seen, it is formed of three sections: a capacitance multiplier, a 3.3V regulator, and the OPT101 itself. The first two stages function to minimise input noise as much as possible, with the capacitance multiplier functioning to almost entirely remove mains ripple. The OPT101 is a monolithic photodiode and single-supply transimpedance amplifier, so conveniently amplifies the photodiode output without requiring an external TIA and biases the device too. The disadvantage of course is that it has a relatively limited bandwidth of ~15KHz, but this should be good enough for applications that require only a slow response time such as a spectrophotometer.

pdDiagram.png

Assembly

The PCB itself can be fabricated using your favorite online service by simply uploading the "photodiode for fabrication.zip" file to their online store. I go with JLCPCB, but others are available. Assembly should also be possible using these services if you provide a BOM too, though some special considerations may need to be made for the OPT101 chip since it is an optical component. Elsewise, you can do what I did and hand solder the components.

pdCircuit.png

It is an option to use a tantalum capacitor for C1 to avoid the microphonics associated with ceramic ones. The device can be mounted to a case with a M4 bolt and is designed such that it has no conductive pads on its back and the area around H1 is grounded. As such, if bolted to a conductive case, the case will be grounded and act as an EMI shield. Using only one screw hole also allows fine angluar adjustment of the placement of the photodiode, should that be required.

R2, R3, C4, and C5 are all optional and can be used to set the gain and bandwidth of the detector yourself, details on this are in the OPT101 datasheet (https://www.ti.com/lit/ds/symlink/opt101.pdf). If you would like to use the chip with its internal gain of 1M$\Omega$ (0.45 A/W @ 650 nm) then simply short R3 or C5 and leave the others empty.

About

This project aims to provide a very simple slow (~15KHz) but low noise photodiode front end, for the use in building scientific instrumentation.

Topics

Resources

License

Stars

Watchers

Forks

Releases

No releases published

Packages

No packages published